Hobbywing SEAKING 130A HV 87010090
Specifications
LiPo cells: 5-12 NiCd or NiMH &: 15-36; Continuous Current: 130A (short time> 10s: 180A); BEC power supply: no; water connection: Ø 5 mm, dimensions: 88x58x23 mm Weight: 182 g
Description
The Seaking control series has been designed for use in boats. All controllers are water cooled and equipped with generously sized nipple for the silicone tubing. The Seaking series is characterized by reliable technology at a small size. These controls are designed exclusively for the control of brushless motors. As an optional battery pack can LiPo, NiCd or NiMH batteries are used. Here, the number of cells is detected automatically (except HV-series).
A special feature of the Seaking 80A HV on a lightning rod. Before the flight battery is plugged into the controller, the capacitors of the controller through a resistor "slowly" recharged. Thus the violent spark is avoided when you connect the drive battery and the gold-contact connector and the electronics are protected.
Through the use of high-quality SMD components, the internal resistance of the regulator is very low. The high frequency gives the Seaking controls a high-resolution and fine speed control. All controllers have a temperature and overcurrent protection. And of course the entire series is equipped with an effective anti-tarnish, if the throttle stick on the transmitter when you turn not on neutral.
The following parameters can be programmed on the controller:
• Operating mode (forward / backward and backward)
• Number of LiPo cells (auto / manual selection)
• cutoff for LiPo (2.8 V / 3.0 V / 3.2 V / 3.4 V)
• Timing (0 ° / 3.75 ° / 7.50 ° / 11.25 ° / 15.00 ° 18.75 ° / 22.50 ° / 26.25 °)
Overall, the Seaking-range captivates with its simple handling and high reliability in practice. The high-grade silicone cables in a flexible design underline the high quality of the brushless controller.
Features
• Built-in lightning
• Automatic detection of cell number (manual setting is possible) for NiMH & LiPo low voltage cut-off
• Water-cooled electronics for maximum continuous load
• 2 operating modes: Forward / forward - backward
• The control range for the motor can be adapted to all common types of transmitter
• Linear, very direct and fast control response
• Stabilized power supply for the microprocessor
• Multiple protection devices: under voltage protection / over-temperature protection / signal monitoring
• Extremely low internal resistance
• Adjustable timing
• Engine shut-off when no signal transmitters or radio interference
• High quality cable with silicone insulation
• Programming the controller with programming card possible
• Programmable controller parameters:
- Operating mode (forward / backward and backward)
- Number of LiPo cells (auto / manual selection)
- Cut off voltage for LiPo (2.8 V / 3.0 V / 3.2 V / 3.4 V)
- Timing (0 ° / 3.75 ° / 7.50 ° / 11.25 ° / 15.00 ° 18.75 ° / 22.50 ° / 26.25 °) |